Every furnace call starts with a combustion and carbon monoxide safety check, not just a symptom fix.
Heat exchanger cracks, ignitor failures, and gas valve issues all fall within our scope.
If you're dealing with a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air, you already know furnace failures carry a safety dimension — carbon monoxide and gas leaks — that most other HVAC repairs don't, so the diagnostic has to start there.

Most furnace repair problems give some warning before they turn into a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air — catching it early usually means a shorter, cheaper fix.
AAA Pro HVAC built its furnace repair process around one idea: diagnose first, quote honestly, fix it right.
We're licensed, insured, and staffed with techs who've spent years specifically on furnace repair, not general handyman work with an HVAC certificate bolted on.

Cracked heat exchangers get flagged immediately as a safety issue, not just a repair line item.
Our crews are trained on standing pilot, hot surface ignition, and electric resistance furnace systems alike.
Diagnosis happens first, and the quoted flat rate reflects the actual confirmed fault.
We understand a dead furnace in winter is a pipe-freezing risk, not just a comfort issue.
Every job starts with a real diagnosis, not a guess — here's the full scope of what our furnace repair technicians handle across Alameda, CA.
Hot surface ignitors crack over time and simply stop glowing — we test resistance rather than replacing on assumption. Techs handling ignitor & pilot light repair carry the specific parts and tools this job calls for, not a generic kit.
A gas valve that won't open or won't seal is tested with proper manometer readings, not just listened to. This is one of the most requested furnace repair calls we get across Alameda, CA.
We use a combustion analyzer and visual borescope inspection, not guesswork. Techs handling heat exchanger inspection & repair carry the specific parts and tools this job calls for, not a generic kit.
We test motor amp draw against rated spec before replacement. This is one of the most requested furnace repair calls we get across Alameda, CA.
We inspect the full flue run, not just the connection at the furnace. Techs handling flue & venting repair carry the specific parts and tools this job calls for, not a generic kit.
A furnace that won't respond to the thermostat at all sometimes traces to a control board fault rather than the burner assembly. Techs handling thermostat & control board diagnostics carry the specific parts and tools this job calls for, not a generic kit.

Tell us the symptom — no ignition, cold air, gas smell, or error code — and we route accordingly.
We confirm your Alameda address and a realistic arrival window.
Safety check first — combustion and carbon monoxide — then full mechanical diagnostics.
Most ignition and control repairs finish same-visit.

Furnace kept clicking like it wanted to light and never catching.
Old furnace was blowing cold air even though the blower ran fine.
They found a hairline crack in the heat exchanger I never would've noticed.
Thermocouple was the culprit, replaced and tested before the tech left.

A clicking-but-not-lighting pattern is one of the most common furnace complaints we diagnose.
Yes — it's a genuine carbon monoxide risk and we treat it as a safety issue, not a routine repair line.
This symptom shouldn't be ignored since it sometimes points to a safety-related fault.
Yes — our technicians are trained and certified on both fuel types.
Gas odor calls receive top dispatch priority.
Call dispatch for a live arrival estimate based on current demand.

Our furnace repair crews are positioned throughout Alameda, CA to keep response times realistic, not just promised.
☎ Call +1-866-805-8548 for Alameda Service